Sciact
  • EN
  • RU

Catalysts derived from nickel-containing layered double hydroxides for aqueous-phase furfural hydrogenation Научная публикация

Журнал Catalysts
, E-ISSN: 2073-4344
Вых. Данные Год: 2022, Том: 12, Номер: 6, Страницы: 1-18 Страниц : 18 DOI: 10.3390/catal12060598
Ключевые слова nickel catalysts; layered double hydroxides; furfural hydrogenation
Авторы Belskaya Olga B. 1 , Mironenko Roman M. 1 , Gulyaeva Tatiana I. 1 , Trenikhin Mikhail V 1 , Muromtsev Ivan V 1 , Trubina Svetlana V. 2 , Zvereva Valentina V 2 , Likholobov Vladimir A. 3
Организации
1 Center of New Chemical Technologies, Boreskov Institute of Catalysis
2 Nikolaev Institute of Inorganic Chemistry
3 Boreskov Institute of Catalysis

Информация о финансировании (2)

1 Министерство науки и высшего образования Российской Федерации 0239-2021-0004
2 Институт неорганической химии им. А.В. Николаева СО РАН 121031700313-8

Реферат: Changes in the structural and textural properties of NiAl-layered double hydroxides (LDHs) (with 2–4 molar ratios of metals) and state of nickel that occur in different steps of the synthesis of nickel catalysts were studied using XRD, thermal analysis, TPR, low-temperature nitrogen adsorption, XANES, EXAFS, and electron microscopy methods. Relations between nickel content, catalyst reduction conditions, state of nickel, and its catalytic properties were revealed. It was shown that the use of NiAl LDH as the catalyst precursor even at a high content of active metal allows for the obtaining of the dispersed particles of supported nickel that are active in the aqueous-phase hydrogenation of furfural. The catalyst activity and conversion of furfural were found to increase with elevation of the catalyst reduction temperature and the corresponding growth of the fraction of reduced nickel. However, a lower reduction temperature (500 C) makes it possible to form smaller nickel particles with the size of 4–6 nm, and a high Ni content (Ni:Al = 4) can be used to obtain the active Ni@NiAlOx catalyst. Under mild reaction conditions (90 C, 2.0 MPa), the furfural conversion reached 93%, and furfuryl alcohol was formed with the selectivity of 70%. Under more severe reaction conditions (150 C, 3.0 MPa), complete conversion of furfural was achieved, and cyclopentanol and tetrahydrofurfuryl alcohol were the main hydrogenation products.
Библиографическая ссылка: Belskaya O.B. , Mironenko R.M. , Gulyaeva T.I. , Trenikhin M.V. , Muromtsev I.V. , Trubina S.V. , Zvereva V.V. , Likholobov V.A.
Catalysts derived from nickel-containing layered double hydroxides for aqueous-phase furfural hydrogenation
Catalysts. 2022. V.12. N6. P.1-18. DOI: 10.3390/catal12060598 WOS Scopus РИНЦ OpenAlex
Даты:
Поступила в редакцию: 22 апр. 2022 г.
Принята к публикации: 27 мая 2022 г.
Опубликована в печати: 30 мая 2022 г.
Опубликована online: 30 мая 2022 г.
Идентификаторы БД:
Web of science: WOS:000816455100001
Scopus: 2-s2.0-85131212307
РИНЦ: 49149764
OpenAlex: W4281724515
Цитирование в БД:
БД Цитирований
Scopus 7
Web of science 4
OpenAlex 11
Альметрики: